Recent content by RadarTom

Problem has been not cutting completely through set at 40a. I have been reading about people cutting 1/4 at 40a, so I'm guessing I need to adjust my input cut height in VMD, to compensate for the roughly 1/8" difference between the tip of the nozzle and the face of the shield?

I have a 2x2 growth series with accumove 2. And I'm struggling to get decent cuts on thin 16ga range. I'm using 9-8208 40a nozzle, 9-8245 shield, and a mech torch. On the VMD screen I have been trying to use book specs for the 52 but it seems I'm cutting way to high. Tonight I just measured...