Recent content by noclinkers

  1. N

    Motors will not engage.

    It doesn't do it automatically when I power up The motors will be moving and then it will blow the fuse.
  2. N

    Motors will not engage.

    OK, got it working with another laptop, but now it keeps blowing fuses on the small circuit board and the motors will not run.
  3. N

    Motors will not engage.

    So, was doing some rearranging of the shop and when I hooked my table back up now the motors will not engage. TM3/Accumove 3. Have checked all the fuses inside the controller and all lights come on that should. Any Ideas?
  4. N

    Change home position on table?

    I just talked to tech support and they said that they could not do it. I could have sworn that I changed it before? I don't understand why it can't be changed? I know on my other table I could set it wherever I wanted.
  5. N

    Change home position on table?

    OK, thanks
  6. N

    Change home position on table?

    I have a TM3 with the accumove controller and need to change my home? position so when I datum it shows up in a different spot if this makes sense? Thanks for the help.
  7. N

    Tech support.

    Not the same. I don't have time to sit by the phone and so I missed the call today. I know there are other ways to get things done, but these take more time and meanwhile I'm down. You guys are changing many things and not for the better.
  8. N

    Tech support.

    Wow, things are really changing! Now we get a number and wait for a call? Part of the reason I bought my table through TM was the awesome tech support. You could call and get going without loosing too much down time. Now it is "we will try to call you by the end of the day"? This sucks!!
  9. N

    How do I?

    I got it, but had to do it the long way. I wanted to make the circle flag from the square one. Any shot cuts for future reference?
  10. N

    How do I?

    Hmm, not working for me?
  11. N

    How to you calculate what to charge?

    I use this one for the most part. http://davekearley.co.uk/downloads/
  12. N

    How do I?

    Say I have a flag image and I want to lay a circle on it and then cut out that part of the flag that I have overlayed with the circle? Thanks, Bob
  13. N

    Custom Bench: Design | Cut | Build S2:E4

    The dxf worked, thanks. What is a EDU, is that new?
  14. N

    Custom Bench: Design | Cut | Build S2:E4

    Files not working for me?
  15. N

    Datum Diagnosis

    I have had a similar issue in the past. My Z axis was out of sinc with where the table thought it was. Have you tried to disconnect the ohmic wire from the tip put a jumper wire on it so you can reach your plate, I start a file in dry run and as the torch comes down to start touch off, ground...
Back
Top