Recent content by Mike Pennington

Issue fixed. Can't say enough how much I appreciate the Torchmate customer service. I really appreciate how Jake took care of my problem.

Done

Hi All, My torch is dragging and firing after being dislodged . The breakaway lights come on when the torch breaks away , but it does not stop ???

where do I find the sp2 upgrade?

Thanks Chad. I didn't realize there was an upgrade to vmd. Thanks, Mike

Would love the cdl or dxf files. Thanks, Mike

Won't work with my Accumove 3 ?

Wow, Amazing work.

Thanks my friend. I love coming down and visiting, but I know you are all very busy. Have been in Reno three times this week.

Hi Guys, probably a silly question, but here goes. I have an easy scribe. trying to use it with accumove 3. How do I make the lifter go down and touch without ohmic. I want it to just touch the metal and then scribe without going down and bottoming out. Thanks, Mike

Great Project. Thanks, Mike

OK, Thanks. I have the latest version. Mike

Hi all. What is the latest version of VMD for Accumove 3? Also, I noticed when I was down there that when you hit Reset Z , that your lifter goes up automatically. Mine goes nowhere, and I have to lift and then hit reset Z. Thanks, Mike Pennington

Thanks. I found and fixed it. I only tried to tighten the spur gear set screws while the motors were mounted. when I removed the motors, I found the set screws felt tight. I lossened them and re tightened them. That fixed the problem. I will take them off again and drill a small divet in the...

Did the configuration reload and factory reset. Still have paly in the y axis . both sides.