Recent content by Local302

Previously the only way I could get the ohmic cap to show up was by bypassing the relay box. So if it wasn't the relay switch in the program then I have no idea what my original issue was and now I can't get the ohmic cap to light up no matter what.

Matt Kobel Fairbanks Pipeline Training Center Alaska Operating Engineers Education Training Trust Fairbanks, Alaska

10 gauge wire from the table to the independent ground. 0 ohm resistance. 1 ohm resistance from material on the table to the independent ground. Toggled the relay on through the VMD software. I have the external relay box. Previously I was able to activate the ohmic cap by bypassing the relay...

Was on the phone with customer support for a while. It sounds like the Acucumove box is messed up. So if they send another one, it will be the fourth box I've had with this setup. Everything's grounded. Got all the continuity where I'm supposed to. I've ran the troubleshooting tests. Pin 2 from...

What happens if you wire it to bypass the ohmic relay box?

I've had nothing but trouble getting the shop's Torchmate 4X4 set up. It has been in the shop nearly a year and we have gotten very little use out of it. We have had to replace our Accumove controller 2 times already. I was finally able to dial everything in and it worked okay for about a week...