Recent content by LECS-Mike

  1. LECS-Mike

    Issues with cad 9

    The Font that the CDL file is trying to find is not installed on that new computer. The font can be installed into that new computer, and then the CAD software by going to File - Install - Fonts. At that point CDL will open fine. Or you have the option to replace the font at the time of...
  2. LECS-Mike

    Flexcut 80 torch issues

    Hello, What is the air pressure set to when purging on the regulator on the front of the unit? Does this maintain throughout the 600+ pieces? What is the air quality like, do you have any photos of some old consumables you can send in so that we can check for contaminants? Air quality and...
  3. LECS-Mike

    Growth series 2×4 accumove 2 problem

    Go ahead and login as an Admin, load the configuration, give the system a reset and that should clear it up. Let us know if you still have any issues.
  4. LECS-Mike

    Growth series 2×4 accumove 2 problem

    The Z DRO position reads correctly, but as there are many complex calculations in the background going on with that Z position, it is possible something needs to be re-configured. If the problem persists through a hard reset (power down the controller, software, and reset) with a dry run, I...
  5. LECS-Mike

    Ohmic Sensing Failure

    Rodger, To temporarily disable the ohmic sensing, this can be done under the Job Setup screen. There is a button that says Ohmic Sensing, either On or Off. When set to Off, the proper way to set the material thickness is to jog the Z axis all the way to the top of its travel until it stalls...
  6. LECS-Mike

    Tutorial/Webinar Videos

    For more on the Torchmate CAD software tutorials, here is a playlist of all the videos combined from start to finish. https://www.youtube.com/playlist?list=PLtmThMSi-HaciwDEBtYnNjBnthHchtKeE
See more
Back
Top