Recent content by LECS Matt

Are you and your guys still having difficulties with your Flexcut 80?

Go ahead and call into the support line and start a ticket. Call times are running about 20 mins right now

Breakaway 1 is the connection for the Torch to the lifter station where the magnet holds the puck in place. Breakaway 2 is the upper limit for the lifter station. Check your connections on the lifter station. On the left hand side you should have a black wire that goes into the lifter block...

Cutting at 40 amps with the Flexcut 80 these settings produce cuts with very little bevel and minimal dross. 18ga 350ipm 16ga 300ipm 14ga 210ipm 12ga 140ipm 10ga 92ipm At 60 amps these settings work well: 3/16" 90ipm 1/4" 70ipm 3/8" 33ipm

The water additive Lincoln recommends is called Green Cut. Its manufactured by a company named Lubecorp. Most welding suppliers like Airgas and Praxair can get it for you or you can go to the following website to find local distributors. https://www.lubecorp.com/greencut-cutting-fluid/

You can create anegative by placing any kind of border around the image and MAKING PATH on the trace and new border. If you want to create a border that is the same shape as the outline of your trace, you can create a MALE TOOLPATH on the external border of you trace (just make sure to turn...

BigJoe there are multiple reasons not why this could potentially not work. First is the possibility that they will get welded together either from the heat of the torch or the oils on the material bind together through the plasma. Secondly, depending on how thin the material is, the air...

Matt is corrected. The main difference between the Accumove 2 and Accumove 3 is the power of the drive cards. Also the Accumove 3 has an additional 6 input slots that are used for Limit Switches on the bigger tables.