Recent content by Larry Cameron

Oh hang on, you have parts for the Blue Screen AVHC still ? as I had to source a part from Onexia, and they reprogrammed a chip for it, can you guys do this still? Larry Cameron RusticMetalArt

I don’t think so this was for the blue screen AVHC controller. RusticMetalArt Larry Cameron

News for anyone that has these parts . Dear Valued Customers, It is with sincere regret that I inform you that Kyndill Controller will permanently cease production, technical support and repair services of its Kyndill AVHC complete systems, Height Controllers and Breakaway Lifter Stations...

Hi Guys, I have a Torchmate 2 x 4 (2012) with a NON ACCUMOVE CONTROLLER and I am selling my 2 x 4 and the new person I assume will need to buy their own Torchmate CAD Software to output the gcode for my Torchmate 4 Driver Software on the Laptop to run. Is this as simple as buying a copy from...

Or as a short cut. Just press “C then “E” Larry Cameron RusticMetalArt

Is the ground bus bar actually bolted to the table BUT to bare steel or painted steel? I would also connect the earth cable properly to the plate that may help immensely. Clamping the wire like that is looking for trouble. I would also change your lead-in to a size at least as thick as your...

Thank you Larry Cameron

Cool thanks again. Larry Cameron

Dnmeistr its the growth series 2x4 not the Torchmate 2or 3. Larry Cameron

Hi guys, I have the growth series 2x4, year 2011 model. I notice the torch can be jiggled approx 1/16” at the nozzle end. This play is in the lifter station. Can you inform me what needs to be changed to firm this up and any instructions ? Larry Cameron RusticMetalArt NZ

Very cool project and showing real world errors like I do :-). Query, what was the sanding disk used on the air grinder on the back plate? Cheers Larry Cameron NZ

Lol ok thanks voodoo magic Cheers Larry Cameron RusticMetalArt

ok thanks. .......... but i do still remember something I read on a forum about changing the sensitivity of the AVHC so it would react slower or faster no? Larry cameron Rusticmetalart

Ohhhh I had assumed there was a setting in the Blue Screen avhc that would slow down the response times of measuring the arc feedback or something and stop it diving so much in corners??? Regarding your previous reply, is it ok table wise to increase that federate ramping as it has worked ok...

Hi guys. I am using a used controller 501A for my 2x4 growth series until mine is replaced or repaired. It dives on the sharp corners like a yo-yo. Can I slow the reaction times down so it is not so responsive in the factory menu somewhere to stop the diving? Larry Cameron RusticMetalArt