Recent content by jlasater

I don't know about troubleshooting that system other than going through the bulletin that Lincoln makes available, but I do know you can turn off the ohmic feature and run the torch height manually to get by until you can have it repaired. I believe you'd just need to run the torch down till it...

As a followup...in mid September, I disassembled the plastic body on the torch and had a look at the pins. I was able to gently push them out from the backside using the attached wires. After trying to flush some cleaner through them, I had the idea to touch a soldering iron to the side of one...

If you're running the LC105M torch, it's probably the two pins others have mentioned. I'm having this issue, and it would appear that the previous owner really cinched down the "retaining cap", the threaded sleeve that goes over the cutting tip and electrode, shoving those two pins in so they...

What speeds are you trying to run the table at? Set it to something like 100ipm, a speed you *know* should work fine. If it still has issues, then I'd start looking at the motor, belt, belt tension, etc. I know when I first got my machine running, the speed was set super high, like 300ipm or...