I read these are supposely better than O-Rings. Could it have twisted/rolled as you were installing it. I have had that happen in the past when I...
I want to create a Pierce Point to locate a hole center for drilling. I know this will harden the material at this area but my holes I will be...
Try going to this link. https://www.facebook.com/groups/128042524552012/ This link was shared with me here. I have been to this link...
Did you check to see if you are set to Dry Run on the VMD? Have you checked all your grounds? Are you settings correct? There could be a number...
Hello all Who is using the Table X? I know from reading a lot of the post on here majority of the users are using the smaller tables. I am trying...
Depends on what you are looking for. Are you doing everything in the CAD/CAM software or importing in from a different CAD software? I only use...
Another possibly is contact your local steel vendors that you are working with. They can sometimes help out. They may not know all the fab shops...
I did send an email to Support as I was working on some other issues we had going on. I was told it could be done but I do not save the file as a...
Is there a way to edit older programs? I was working on a new program and I tried editing the program before I saved it. I was able to edit the...
The poll would only let me choose one material size. We use all the sizes listed.
I have watched this video numerous times. It gives about the same information as the class does. I am better off doing the nest manually in the...
We have a Table X with the Flexcut 125. Nesting has been an issue when I use the nesting feature in the cad software. We had issues using it...
Separate names with a comma.
