Recent content by jdh239

Well, I am going to chalk this one up to an older laptop and/or program issue. Shortly after posting this my TM4 program froze up. I killed it, relaunched it, setup all of zeros, and discovered it was having tooling issues... kind of like it didn't completely load the setup file. I corrected...

My 2x4 was working perfectly before I did a realignment on it. Now when I go to cut something it cuts the first point, moves to the second point and then the avhc never drops. I then get the error about the pierce signal. I think the pierce signal is legit, because the torch never drops. I...

I have someone wanting some stuff custom made (bracing for a floor or joint that has been cut). I told them I would try to refer them to someone closer to their area. When the forums were on Pirate4x4 there was a map that we had signed up on. Unfortunately that map no longer exists. Is there...