Recent content by Jason Bauer

  1. J

    Machine Torch tip catching when cutting across a slat.

    Auto Mode.
  2. J

    Machine Torch tip catching when cutting across a slat.

    Yep, Pierce is at .15" cut is at .06" as specified by hypertherm. This isn't happening at the pierce, this is usually at least a few inches into the cut. It will have a nice clean cut going then sometimes when crossing a slat the slag builds up and catches the tip.
  3. J

    Machine Torch tip catching when cutting across a slat.

    Ok we have been having an issue with the tip catching/dragging with the THC on our 4x4 with PM65. What I've determined is happening is we get some blow back slag every once in a while when crossing a slat. Its always a slat crossing that it happens at, but doesnt happen at every slat. We...
See more
Back
Top