Recent content by hsip

sorry about that i ment to say hi speed ,no luck with the cables ,i disconnected the gantry from the stepper motor in the x axis and it slides free from end to end but it only hits the hard stops evenly on one end of the table ,the other end is off approximately 1/4 .and i also need to adjust...

i checked the table and it is square to about 1/32 on an inch ,and i am running in express mode and full speed ,i will go try a new cable and port on my lap top ,thank you

the company i work for has a torch mate 4X4 growth series plasma torch and i am having issues getting it to rapid in between cuts or just rapid moves in the X axis in general ,if you move at any speed over 120 in/min it will throw an error that i have lost connection with the signal generator ...