Recent content by High Rollin'

  1. H

    Failure to detect material surface

    After running through the diagnostics I tried to run the program and will attempting the very first cut I received the same error message. While looking through the setting under the input tab I noticed the homicide cap light was not on, could something not be getting detected? I'm shut down...
  2. H

    Failure to detect material surface

    I finally had time to get back to the table to trouble. When I set the relay out to on the ihs detection light stayed off. Then I ran the torch down to contact the steel and the detection light came on as soon as it is removed from the surface light goes off. I also connected the ohmic wire to...
  3. H

    Failure to detect material surface

    I regularly get the following Error in VMD while cutting " IHS Error: Failed to detect material surface. Check work ground." This error occurs intermittently but when it does i can't find what causes it. I check grounds, move the ground clamp, clean the material, clean the torch head, move...
  4. H

    ProText

    Thanks for the response. I went in and edited the start node and the text wrapped around the shape as intended. As for the Icons on the top left i have no idea why they don't match Protext as i have the upgrade and did exactly what was shown in the video and the text followed the shape.
  5. H

    ProText

    Working with ProText and when I start typing it starts to the right or center of the object instead of to the left no matter where I click then I can't get the typing formatted to fit the shape right. Is there a way to get the typing to start wherever I click?
Back
Top