Recent content by HansenMech

First image link doesn't seem to be working.

Hey guys, I have a new job coming in I need to make some angled cuts I haven't tackled before. Here is a few details with drawings. Looking to see if anyone as any good advice on set up and operation for this.

I spent $46,000 on my table as I got the super deluxe Torchmate X 5x10 and the optional tubing cutter on the side (During the short time they had that). The japanese have been building super reliable laser's since the mid 90's, that being during the old anilam days. Why in 2016 did I get a...

So now the new issue is right at the start. After datum runs down the Y axis and hits limit switch, it does the programmed offset, but then slowly backs away endlessly which is only stopped by me manually (Doesn't find back limit). Configuration has been reset, module and computer restarted...

Hey guys, Have a job coming up in a few weeks that is all aluminum. Shop fab is no problem between the dynasty and spool gun but kinda struggling with option's for the field install. Have a diversion 180 that goes AC but it's plug style isn't happening on the ranger 250 I do much install...

Be extra careful with those magnets. I have used a 2500lb one at my day job and have been around when guys either don't clean up plate enough or get it all twisted and.... Slam that full sheet of 3/4" comes down quick

LK Goodwin seams to have some reasonably priced stand alone bridge cranes. Dependingon exact size 15'x30' @ 4K lbs is right about $15K

I was thinking even a small 15'x30' bridge crane would be small enough not too cost a ton$$$ but big enough to span over my table and any racking system/welding table parallel with it.

While so much on this forum is focused on cut quality and CAD programming, what about the simple stuff? Like getting those sheets on and off before/after cuts. A lot of time can be wasted with something so simple. I currently have to just "Figure it out" with the forklift but am searching for a...

Hey Guys. Finally getting through all the wiring and such to get the shop fully operational.. Having trouble with how I should orientate my storage/cutting rack. I have 2 saws which I am trying to have usable and not block my access to the storage. Here are pictures for best explanation.. Let...