Recent content by GarageNerd

in the middle of job ohmic sensing stopped working. followed the bulletin and checked wires/voltages/connections to the point it said the accumove may need to be repaired. i jumped ground to pin 4 on vfc and vmc didnt register a sense and the voltage measures 12. anyone run into this before? im...

Finally allowed to do business again and the pc isnt powering on. I ran a job, it sat then I went back out and it had disconnected from accumove. Shut it down, no life when I hit the power button. Edit: the power cord is good, it works on another pc Any ideas?

trying to figure out how to calculate the length of an arc in torchmate. im designing a box with rounded edges and i need to know how long of a strip will cover said rounded edge. how in the world do i do this in the software?

is there a way to just add a pierce to something in tm cad without having it attempt to cut a shape?

i would love to start routing some projects, is there any software bootcamps around?

when are we getting a new software update? im having multiple issues that are apparently known about for about a year now that have serious impact to productivity. if machine stops during plate marking it looses position and offsets again if i stop the machine the torch doesnt lift after the...

This 100% fixed my problems. Much better than the font cut 24g answer I got from someone on the tech support line.

Anyone have any luck cutting 24g? It pierces but no move signal. Edit. Just saw thread below on thebtopic.

Also, wouldn't it be possible to rotate the dial and make a second engraving on the inside for daylight savings?

That's pretty cool, can you post up a good resource where we can find info on calculating the angle for our lat?

Turns out there are multiple things mechanically and parts are on the way.

Yeah I get at least .2 error u and y even in middle of jobs. Greased zerks and cleaned rails yesterday.

I've got the guide for the 4400 but it's probably older, any updates for this year?

Followed ma guide and still loosing square on y axis. Belts dont appear to be slipping Any ideas?

so im trying to avoid data issues on a metered connection is why mtsc is my prefered. using teamviewer now.