I have the accumove 2 and I must have hit a button or something, because now it traces everything before it cuts it. Any help would be awesome, thank you in advance!
I have been running my table the last 3 years off a laptop. I went and switched it out with a PC, when I installed the vmd driver software it prompted try order or register. I don't know what or where to find these. Apparently I have 21 days to resolve this or I'm gonna be dead in the water...
Yes it's a growth series 2x2.I did all that as well and it was very jerky when I spun it. It didn't want to spin freely at all. I just ordered another motor for it from torchmate.. hopefully it fixes the problem. The timing for my issue sucks because I'm swamped.. lol
Hey guys/Gals.. Got a question on the torchmate stepper motors.. I have a slipping issue and I believe its inside the stepper motor itself.. The backlash nut seems good.. When I disconnect the worm and spin the motor it feels like a gear jumping or something.. Anyone encounter this before??
I'm not sure what happened but every time I try to weld something it blows it up.. Any idea how to fix it? The measurements never move.. Any help would be a huge help!! Thanks in advance! .
My machine has been running without issue for quite a while now.. But today the temps dropped to about 25-30ish degrees. (My shop isn't heated at This point) When I went out to fire everything up it wouldn't connect for anything.. I checked my cords, and firewall settings with no luck.. The fan...
I have a torchmate 2x2 with accumove 2 that i've had for a little over a year. I bought the table with no knowledge of how anything worked.. all self taught. the basic videos on the lincoln website helped get me get going but there is sooo much more I have no clue what it does. I don't want to...
I re-adjusted everything and took the 90 off.. cuts great! 100% improvement for where it was! I think it was the combo of both the internals and the height of the torch.. THANKS GUYS!!
Im sorry I didn't tell what kind of table I have.. its a 2x2 growth series table and hypertherm powermax 45. it chatters in most directions I checked and there is slop in the cassette. I will try to adjust it and go from there..
Can someone tell me why this is happening and how to fix it please. I am getting very frustrated with the chatter. I know somethings out of whack and i can't figure out what.. thanks in advance
I would like to know the average price rate on both. I have ended up on both ends of the spectrum in this aspect, either I look like a highway robber or i'm practically giving it away.. I would like to find a happy medium but each job is so much different than the last.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.