Recent content by Dan Spec

Thanks Jason, yes getting the material straight on the table was important. Thanks for that tip. What I ended up doing was to make a single cut on a 4'x8' sheet from the Accumove point tab as described in the Tips thread listed at the top of this forum, to get two 48"x48" plates. Then in the...

Well, I used the line tool to create single lines across the sheet. Then created online tool paths that was used to fix the river at 22:22 in this video. (there is audio lag so what is being said is a minute or so before this point in the video). Wish me luck - going to try it out next week...

Thanks for all the info, and files everyone has posted in this forum. I am very grateful. I am using the Torchmate EDU-s software, and have uploaded a file I am working on. I used 4" horizontal rectangles and 2" rectangles vertically in an attempt to create blanks that students can practice...