Recent content by Carlos Merino

Can’t remember the font used right now but don’t worry because I have to make another one and will check that out Once I know, will share it with you

Just wanted to share with all you guys our own design, plasma cutting, polishing and powder coating all in house of our Flag. This will be the mayor star of a new project we’re working on of course, this one in particular will be placed in the main entrance of our shop

Here some drawings, hope they're useful Welding

Sure, tomorrow will check my files to see where I have them

Yes, although it’s not been updated from some time now cause been involved in military contracts and didn’t think in posting them. This year we will resume an old project of retail selling through e-commerce and we will be posting quite a few Our Instagram is @bluedogmiami

Agree 100%. Attaching some pics, it came out really cool

Hello, I’m doing a new project that requires 1 inch fonts in 14 ga carbon steel so far have not been able to make it happen during the cut process since the letters are small and just loose them any suggestions on a good font I can use? Basically I’m writing the Pledge of Allegiance in a...

Hello, I have a Flexcut 125 and want to try making some dies for a press brake what I’m looking for is how to use the Edge Start mode with 3/8 or 1/2 inch steel Any suggestions?

I was really enthusiastic in doing it with almost no previous experience and therefore all went wrong. Imagine all the mistakes you can have, I had all of them together! Hope to be repeating it in the near future and will share it

Morning everyone, just managed to do some small touch ups and play with the letters for a sign in my BBQ area. If you see some letters (C) you’ll find that the torch from time to time dives in to the material without a reason. Sure will find the solution once the quarantine is over Sign powder...

I don't understand how you turn it in order to get angles. Can you share the dxf files?

Amazing! Great idea!

It was done with 1/4 plate, right now I'm finishing a new drawing that can share, since this one had some minor details To be honest, it's so rigid that I think it can be done with 3/16

The good about having a Torchmate is that you can "enjoy" the shutdown Posting a couple of pics of a welding table we just did last Friday. In the pic you can't see them very well but it has square and angle lines. Also our logo engraved We used all the machine has, pen marking and flexcut...

Thank you for your reply! Here the pics