Recent content by Bo185

OK up date, so took the belt off the X axis motor. Moved cassette by hand and had some ruff places slowing it down. So moved the gear out of the way and the cassette moved like butter. Gear was out of adjustment slowing cassette down. Adjusted correctly and we'll see.

That would have been nice to know, when I bought it, or when I replaced the shaft twice. I have check for anything rubbing or slowing it down. I think its the cassette honestly as I seen on the old torchmate forum on PBB guy had near same issue and is cassette was rusted. I will take the...

#1 all set screws were dimpled and lock tited during install. I also have spli marks on the gears, spurs, and jack shafts to visually see if it moved and still good. #2 Will check jackshaft (its been replaced twice already as well as its spur gears. #3 Gantry is tight in all axis, just...

Got a TM2 with AM3 and I am getting random issues when cutting lettering and circles. On circles it will cut out of round by jogging in a little so its not perfectly round. Its not the file as I can cut same file mult times and it changes places or cuts normally. Its never in same location...

You get a C/D letter and end up in court it, its what a Judges says and they all have their own opinions and can pretty much do what ever they want, granted you can appeal but even going to court is $$$$$$. If I make something and change the logo or name a certain percent, I am still selling...

Technically under the law for signs, yes, even if you aren’t making a profit off of a trademark, you are still reproducing it without their consent. Of course, there’s not much chance you’d get caught if its for personal use, seeing as you and me, are small potatoes and not worth anything to...

Unless you requested us steel, you would get import steel typically as it was cheaper and unless it was ink'ed you wouldn't even know were it was from actually. So if your metal was ink'ed stamped USA there is no way for you to know were it actually was made. The supplier could have just been...

He just does it . Unless he stating he is selling them or paid money or has a website with them on it most get by. Ford isn't as bad. Like I said with the Harley stuff they have an dept for copyright protection. And one call from someone disgruntled and you would get a C&D letter in mail...

Yeah I just didn't like that font, customers didn't either at least some so ended up with the font used in the ends zones, and older stuff. So it works, customers are happy. Need to update them, as I have been busy lately, getting pre-mades done for this fall for stock items. As well as...

These are all powder coated. The fire pits were painted at first but now I use a high temp powder good to 1800*.

Makes sure to note your license Number on facebook page and website I believe it states this in the contract specifically but would have to look. then just sticker everything. I also hang a notice in my booth next to my hog stuff at shows etc.

Yeah I am in Jacksonville. Shop around I got a better deal from JMS in Jonesboro recently and they deliver for free if your on a route they go regular. Problem too is finding stock as the rep said sheets usually go fast. So I'll buy what I need a few extra sheets to last couple months now.

Did you get a Hog license? The crafter license is cheap. They give you stickers and lic number. I would look in to it being in NWA for sure.

I have not added another fan haven't had time and since my box is inside my office its A/C temp controlled probably won't. I'll get some temp numbers next time I run some large files stuff. Also make sure to clean the fan filter. I also would remove the cover and clean the inside. Just be...

Look at the AHP Alha tig since you need to do AL its a 200amp machine $800ish with tons of features 3yr warranty. Unless doing alot of long welds tig it.