Recent content by Bentup

  1. B

    Z Axis Retracting

    We were experiencing some technical difficulties with our table and I hit reset factory defaults as the table would not cut a full sheet. Now when we are cutting our torch retracts fully every time we cut (at a very slow pace), whereas in the past we could set the height where ever we wanted it...
  2. B

    Text to Arc

    I have a sawblade that I need to put words on. What is the easiest way to arc the text to the saw blade?
  3. B

    Compatible Fonts

    Thank you so much! I knew it had to be something simple. However, some of the fonts loaded and some not. Any suggestions?
  4. B

    Compatible Fonts

    What are some compatible fonts for the Cad/Cam software? Look to install some new ones for some classy signage.
  5. B

    Ohmic will not work

    Well, we are back up and running thanks to Susan and Casey at Lincoln. We adjusted the breakaway magnet, but the main problem was in the Advanced tabs, we set something different on Tool 1. I learned a lot about the table the last 2 days, I am certain I can cut basic things on my own now.
  6. B

    Ohmic will not work

    Everything is set to the Hypertherm Specs the way Sue has always done. She always resets the specs before each job, and that is what I did every time I tried to run the table for the last two days. It runs, but does not jog up as it should. It maintains a constant height and then hits break...
  7. B

    Ohmic will not work

    OK have that figured out, and it cuts, but like I said this morning, it touches down and does not bounce back up the way I have seen it in the past, so it hits the breakaway soon after it starts. I notice that the AVHC light is not on but the lockout is. Can this be that problem? How do I...
  8. B

    Ohmic will not work

    I'm sorry but I don't know where to change it, and Sue is not home to help.
  9. B

    Ohmic will not work

    OK, let's take a step back, first let me say that my frustration comes from yesterday being my first day cutting solo as Susan has been trained in Reno, and always does the designing and the cutting. Needless to say, it looks like "I broke it". So I went back out this morning, checked all...
  10. B

    Ohmic will not work

    I will check tomorrow morning and reply with what I see. But I do believe it does retract to pierce height.
  11. B

    Ohmic will not work

    The connection is good, I jumped the wires and the torch fired.
  12. B

    Ohmic will not work

    OK did everything listed above, turned the relay output on, came down, detects but no fire. Went back in to check relay and it was off again so we turned it back on. Can I just take a knife to jump the wires or wahat is the best way as I have no bare wire showing.
  13. B

    Ohmic will not work

    I don't understand how the relay box is working if I take the wires off the back. I'm trying to learn something, be patient with me.
  14. B

    Ohmic will not work

    I went out, tried it again: torch came down detected light flashed torch began cycle but no fire I do not understand what wires to jump on the back
  15. B

    Ohmic will not work

    I did not fire the torch, just touched down the tip to see if the light came on as Chad mentioned in a previous post. No error codes on the cutter. All wires and plugs are connected.
Back
Top