Recent content by audigger

  1. A

    CHEAT SHEET

    Does any one have access to a simple abbreviated guide / cheat sheet to refer back to while processing a cut file?[ in layman's language please]
  2. A

    Maintenance

    The reason i want to change the bearings is the previous owner had a lot of dirt buildup and if you leave it it can migrate into the grease behind the seals and the extra friction can make them roll with more resistance . Not sure if he ever set up the router but he did include a unused...
  3. A

    Maintenance

    So with my torch carriage 1 of the four bearings doesn't ride flat on the flat bar [ because of a 50 thousand twist] also the other 8 bearings [ mounted on aluminum blocks] are engineered wrong because they do not touch the upper and lower rails along the same axis? unless they serve a different...
  4. A

    Maintenance

    So i have cleaned up the carriage but to set the bearings ,there has to be a tutorial somewhere?
  5. A

    Maintenance

    Dnmeistr has posted it ,[ GS Alignment,png ] ,there should be a more detailed procedure available!
  6. A

    Maintenance

    So i have taken the carriage apart and cleaned & inspected everything! i have leveled the parallel tracks with a builders laser level What i have found is the gantry has a slight twist ,so if you reset the bearing height on gantry to .120 inch in the 4 places shown in the tutorial one of the...
  7. A

    Maintenance

    H i have a 4x4 growth series table about 4 years of use. I have binding problems have done the usual to fix the problem still binds intermittently. So i would like to take it apart replace bearing's & set everything where it should be! Is there a in depth tutorial on what i want to do? thanks...
  8. A

    Height control

    Have a 4x4 growth series table - accumove 2 . Today when i cut a object it stopped. So i start from beginning. Only way to move is to press reset? The height control motor is moving on its own until i press a up or down arrow . press the stop button a couple times , press run button the stop...
Back
Top