Thank you!
I'll try that. Would is the minimum radius you'd recommend on a corner? I'm cutting out type that has been converted to paths. Smallest I go on type height is 1".
I also tried checking rounded corners in the toolpath menu but it made no discernible difference.
I've been cutting some 16 gauge steel and I'm having trouble getting crisp corners. If you look at the attached photos you'll see the corners seem to blow out or bow.
Running the book settings at 40 amps. Have varied IPM from 150 IPM to 400 IPM. Doesn't seem to make a difference. Tried new...
Just got my 4800 and despite a delivery issue I have been having a blast getting up to speed.
I was hoping someone could share some settings for 11 gauge aluminum. I have mild steel cutting beautifully but the two tests I just ran on aluminum aren't the greatest. Edge quality isn't crisp with a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.