So who doesn't need a nice Wine Barrel Table? Well I'll take the wine for sure but one of our employees needed a nice "rustic" looking bistro table for his bar at the house. One that would really tie the room together. Add some LED strip lights and what a centerpiece to chat about over some cheese and vino. Check out this fun and very creative project. Build of materials for this project. Equipment: Torchmate TMX w/ FlexCut 125 PowerMig 210 MP Multiprocess Welder Shop tools Propane torch Material used: (total) Wine Barrel (1) 48" x 48" 3/16" HRPO Sheet (4) 1" x 3" x 10' pine boards (1) 48" x 48" 1/4" plywood (1) 40" diameter 1/4" glass (8) rubber standoffs So as you can see there is a TON of clip art that was used in this design. Grabbing and laying out the 22 (yes 22) pieces and getting them into the design was probably the most time consuming of this design. Once all of it was put into place... the real work started. Being that this was going to end up being 40" in diameter a lot of the detail needed to get toned down and some of the details needed ONLINE features vs. SHAPE features. So after shaping the wood and "flaming" the outside with a propane torch we generated a circle to place the LED under that would light up the underneath the center "9". After cutting both the wood and metal the decision to paint or not to paint the top. After some deliberation while I was sanding it was better to leave the result sanded and clear coated instead of painted. The LED lights were trimmed and stapled to the top inside ring of the wine barrel and the wires fed through the bung. We cut a few small brackets welded them to the top metal ring to secure the top to the barrel. The lights add quite the touch and since they are programmable you can really set the mood. The flame job of the wood matches the barrel and its aged look. It is all about the finishing and the additional pieces that set this Wine Table apart from the rest. Provided is the cdl/dxf of the table. Let us know any questions or show us your projects. Chad
Very cool project, thanks. I do have a question. What was used to sand the top of the steel, just a standard 120grit flap disk or some other item?? Thanks Larry NZ
Beautiful work. I really appreciate the effort you guys are putting in to this DIY series. Thank You , Mike
Those wire wheels work for removing dross? Every time I tried one it just spits wire all over the place and it's a bitch if you get your finger too close. Why 3/16" material? Seems a little overkill for this project.
Those wire wheels are great! I haven't had the wires come out of the disk very often; they definitely deteriorate over time, but it has significantly longer life than other discs that I've used. It does a GREAT job on getting the dross off.
