We were experiencing some technical difficulties with our table and I hit reset factory defaults as the table would not cut a full sheet. Now...
I have a sawblade that I need to put words on. What is the easiest way to arc the text to the saw blade?
Thank you so much! I knew it had to be something simple. However, some of the fonts loaded and some not. Any suggestions?
What are some compatible fonts for the Cad/Cam software? Look to install some new ones for some classy signage.
Well, we are back up and running thanks to Susan and Casey at Lincoln. We adjusted the breakaway magnet, but the main problem was in the Advanced...
Everything is set to the Hypertherm Specs the way Sue has always done. She always resets the specs before each job, and that is what I did every...
OK have that figured out, and it cuts, but like I said this morning, it touches down and does not bounce back up the way I have seen it in the...
I'm sorry but I don't know where to change it, and Sue is not home to help.
OK, let's take a step back, first let me say that my frustration comes from yesterday being my first day cutting solo as Susan has been trained in...
I will check tomorrow morning and reply with what I see. But I do believe it does retract to pierce height.
The connection is good, I jumped the wires and the torch fired.
OK did everything listed above, turned the relay output on, came down, detects but no fire. Went back in to check relay and it was off again so...
I don't understand how the relay box is working if I take the wires off the back. I'm trying to learn something, be patient with me.
I went out, tried it again: torch came down detected light flashed torch began cycle but no fire I do not understand what wires to jump on the back
I did not fire the torch, just touched down the tip to see if the light came on as Chad mentioned in a previous post. No error codes on the...
I toggle on and off, hear no clicking. Took the orange wires off the screws and ties together, touched torch to material and it lights up. Any...
Happy New Year! Is there a trick to cutting out a registered trademark?
We have a Growth Series 4x4 table and we are trying to cut an image out of 16 gauge stainless perforated material that has 1/8" holes. The torch...
Is there a way to print all of the fonts that are installed? Wanting to print these out to include in a binder for easy reference. Thank you in...
This is still not working for me. I have the P4 showing in the job pallete. when I select the images to basic weld, the line disappears.
Separate names with a comma.