Was cutting intricate piece almost done then crash, probably a little too slow for alum, anyway I tried to reposition torch and hit run from...
I had a direct short in one of the cables going to a stepper motor , it smoked a board inside the acc #2. Replaced cable. Works fine
The multi process welders. If I recall don't do a/c tig. Personally I would get and I have separate. Machines.
Somebody's getting serious. Nice work
reverse polarity usually on the aluminum rods
Will try it , the 5200. After opening will harden up in the tube in no time
Make up a plug adapter ?
I was looking at one to make patterns in metal like fish type scales. Now that it will serve two purposes will have to pick one up
stainless hose clamp around torch cap end , trim end and attach terminal clip
alright I am here in reno, thanks for the heads up on the sierra grand resort. wow what a place.. very reasonable rates and food coupons as...
Put some expanded metal underneath, so when torch comes down it won't push and deform the the metal When ohmic sensing . Depending on part...
just confirming my slot for may 18-19, as I have made travel/acommodations plans..
I have reached my message quota. Please. Hook me up
Separate names with a comma.